I am a new member. I read your 55L7200 (& also 55L5200) review. I own the 55L6200U TV. It appears from your review on the 7200 model that the Local dimming is what is bad. The difference between 6200 and 7200 from specs appear to me as 6200 is a 120Hz vs 240 in 7200 & No local dimming. I actually love the Picture Quality on my 6200U.
But I am no videophile or an expert. Also the price for 6200 is considerably lower than 7200. I would request you to review the 6200 model please and also post the picture settings if possible. Your help is very appreciated.
Thanks in advance.
Calibration report using these settings:
TV software/firmware version tested: 0.7.2.0 July 4, 2012 (FW: 0150)
Below you'll find the settings I found best for viewing the Toshiba 55L7200U in a dim room via the HDMI input. Your settings may vary depending on source, room conditions, and personal preference. Check out the Picture settings and calibration FAQ for more information.
Calibration notes: In the best default Mode, Movie, the 55L7200U measured quite blue (almost 8000K) with too-dark gamma. The main culprit was an errant default color temperature preset; when I changed it from "2" to "0" the grayscale measured a much more respectable 6900K.
As with previous high-end Toshibas like the TL47515U I tested last year (http://reviews.cnet.com/flat-panel-tvs/toshiba-47tl515/4505-6482_7-34504807.htm) my calibration revolved around a basic choice: to DynaLight or not to Dynalight. The Dynalight setting, which controls local dimming, did cause black levels to improve significantly when engaged, but the tradeoff was poor gamma and shadow detail. I ended up using the least aggressive setting, Low. Even in Low mode the gamma/shadow detail tradeoff is significant, but I chose it for its significantly better black levels than Off.
The Static Gamma settings has a massive 30 presets and I only measured a few (+15, +10, +5). I settled on +5 as the best compromise between low and high light output levels. It's impossible to get a flat gamma if you leave DynaLight on.
The two-point grayscale control worked well, but the Color Master CMS proved impossible to adjust with window patterns since Red and Blue measured too dark. I left it turned off as a result and adjusted color using the TV's blue-only mode.
-- Picture settings menu:
Picture mode: Movie
Advanced Picture Settings submenu
Base Color Adjustment: [grayed out]
Color Temperature: 0
Auto Brightness Sensor Settings: [Off]
Dynamic Contrast: 0
Static Gamma: 5
Noise Reduction: [both settings Off]
Edge Enhancer: [Off]
Expert Picture Settings submenu
Test Pattern: Off
RGB Filter: [all three colors On]
White Balance: [Window Display Off]
2pt White Balance:
PIC SIZE remote button: Native
Note: This post was edited by its original author Added link to calibration results on 08/03/2012 at 8:38 AM PT