Question

some problem during using this chip in my design.

Now I am going to use P871pc768 in control the DC motor which will be used in Automated equipment. The function is to generate pwm wave and ad wave, and encounter some problems, I hope friends can help.https://www.zeanoit.com/pdf/cd-P87LPC768FD,512.pdf
My question is that is this chip can be multi program? In the datasheet ,The description is 4K EPROM but somewhere also show it is OTP 4K ROM. So which one is correct . or it is just one time program?

1.There are two configuration bytes of EEROM inside the P871PC768. Therefore, when programming the chip, do you need to program the EEROM separately in addition to the programmed hex or bin file?
2.And we found this 8-bit Microcontrollers - MCU is obsolete. So Is there any replacement of this chip P87lpc768fd?
3. does some one have P871PC768 a program file or test code?

Discussion is locked

Answer
Follow
Reply to: some problem during using this chip in my design.
PLEASE NOTE: Do not post advertisements, offensive materials, profanity, or personal attacks. Please remember to be considerate of other members. If you are new to the CNET Forums, please read our CNET Forums FAQ. All submitted content is subject to our Terms of Use.
Reporting: some problem during using this chip in my design.
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
Comments

CNET Forums

Forum Info