project at hand

May 29, 2016 1:27AM PDT

I would like to mount a micro sd card to my LED television circuit board. Would anyone out there know how to make that possible?

Discussion is locked

Reply to: project at hand
PLEASE NOTE: Do not post advertisements, offensive materials, profanity, or personal attacks. Please remember to be considerate of other members. If you are new to the CNET Forums, please read our CNET Forums FAQ. All submitted content is subject to our Terms of Use.
Reporting: project at hand
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
- Collapse -
super glue
May 29, 2016 3:24AM PDT

glue it right on anywhere you'd like. Use the plastic edge rather than the contact side and you'll do no harm.

- Collapse -
Re: SD card
May 29, 2016 3:28AM PDT

Have a look in the technical manual. But I think that using the USB port is much easier.

CNET Forums

Forum Info