Thank you for being a valued part of the CNET community. As of December 1, 2020, the forums are in read-only format. In early 2021, CNET Forums will no longer be available. We are grateful for the participation and advice you have provided to one another over the years.

Thanks,

CNET Support

General discussion

Network probs

Aug 7, 2004 10:23AM PDT

I'm trying to set up a network between my Win XP and my Win 98 SE. I've run the wizard and am told the network has been set up on the XP machine. I then put the XP CD in the 98 machine, run the wizard, the computer restarts as it should - then tells me that wizard cannot complete the network setup - cannot find network hardware.
I've run the troubleshooter - and Iwonder if the network card (a Broadcom 440x10/100 integrated controller) is compatible.
I've also tried to set up using homenet help - but no luck there iether. Can some kind person help?
David

Discussion is locked

- Collapse -
Re: Network probs
Aug 7, 2004 10:50AM PDT

I don't read where you installed the network card drivers. Microsoft doesn't do this for us. Also, no details on your network.

Bob

- Collapse -
Re: Network probs
Aug 7, 2004 11:22AM PDT

Bob - I put a network card into the Win 98 machine - how would I find. Where would I find the driver?
And what network details do you need?
DAvid

- Collapse -
Re: Network probs
Aug 7, 2004 12:35PM PDT

The card would come with a make/model, a driver CD/disk. Microsoft doesn't fetch or install drivers for much hardware. You do this work.

Your network would be described by you. We can't guess what you have wired up.

As a short example, here's my network...

DSL modem to the Linksys router. Then PCs connected to the router.

Bob

- Collapse -
Re: Network probs
Aug 7, 2004 2:28PM PDT

I have a dial up modem to the internet and the two computers are connected with a patch lead. Is this what you need to know?
David

- Collapse -
Re: Network probs
Aug 7, 2004 3:37PM PDT

First, did you install the drivers for the network card? Does it show up on device manager and show as working properly?

Second, you cannot use a normal cat5 network cable to network two machines, you need a "crossover" cable.

- Collapse -
Re: Network probs
Aug 7, 2004 3:52PM PDT

Yes, device manager shows it to be working properly. It must be the cable - perhaps the shop sold me the wrong one. I'll buy a crossover cable and hope that does the trick. Thanks
David

- Collapse -
Re: Network probs
Aug 7, 2004 4:07PM PDT

Oh - I just checked in 'My Network Connections' which shows LAN or high speed internet to be enabled and the Dial-up internet connection as being connected and shared.
Does this make a difference?