Thank you for being a valued part of the CNET community. As of December 1, 2020, the forums are in read-only format. In early 2021, CNET Forums will no longer be available. We are grateful for the participation and advice you have provided to one another over the years.

Thanks,

CNET Support

Question

Network Attached Storage

Apr 5, 2015 12:22AM PDT

My Cisco NSS322 is now inaccessible after a power failure in my office. My data was backed up to the cloud, so it was not a total disaster. I have taken the NAS home to work with it on my home PC to get it functioning again. In order I have a cable modem with a NetGear N600 Router attached to it. After connecting the NAS to the Router, must the PC that I am working from have a wired connection to the router, or can I use a wireless connection between my PC and the router to go through the NAS setup procedures?

Discussion is locked

- Collapse -
Answer
I gave this document a quick read.
Apr 5, 2015 2:25AM PDT
- Collapse -
Answer
I Always Use Wired for Router Related Security, but....
Apr 7, 2015 9:32AM PDT

...as to whether you might be able to use a wireless connection to setup the router and its NAS, it depends on the settings. If you're referring to the actual router settings and the ability to access them, some routers allow either wireless or wired by default to access and change router settings.. Still, because it's far to easy to gain network access through a wireless connection, I make sure the settings access in the router is only allowed through a wired connection.. It's just a little safer.. As to your specific situation, you'll need to check the settings.

Same thing regarding connecting the router to the NAS.. Although such wireless connections are available, I always connect it wired.

Hope this helps.

Grif