General discussion

LN52B610 Wont Allow me to change source input

Hi,

Had this set for almost 1.5 years. After plugging the unit back in (I had to move a power cable) it will power up, but will not allow me to change the input source. The buttons on the side of the TV also do not work.

It will power down.

Tried firmware upgrade, but enter key on remote wont work. So I cannot start the firmware upgrade process.

Confirmed and replaced and confirmed batteries in remote.

Noticed that power light flickers furiously and randomly when powered on.

Ideas? Suggestions?

Discussion is locked
Follow
Reply to: LN52B610 Wont Allow me to change source input
PLEASE NOTE: Do not post advertisements, offensive materials, profanity, or personal attacks. Please remember to be considerate of other members. If you are new to the CNET Forums, please read our CNET Forums FAQ. All submitted content is subject to our Terms of Use.
Reporting: LN52B610 Wont Allow me to change source input
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
Comments

CNET Forums