 | Thank you for being a valued part of the CNET community. As of December 1, 2020, the forums are in read-only format. In early 2021, CNET Forums will no longer be available. We are grateful for the participation and advice you have provided to one another over the years. Thanks, CNET Support |
Changed firmware from 2008.9 to 2007 for obvious reasons. But now I would like to go back to 2008.9. 2007 made everything worse. Can someone help!
Thank You
Discussion is locked
Jst1mn,
It may require a technician call, since 2008.9 wasn't released on the website.
I'm not sure I understand your question, though. What is the "obvious" reason the firmware was downgraded?
--HDTech
Sorry, I should have worded it much better. TV was turning off then on a lot during viewing. When I read all the post I thought I was doing the right thing. I switched from cable TV to Fios and it seemed to be happening more. Should I not go into matters I do not understand?NOOOO. ? I had to make the change. Now the TV quality is terrible and it still turns on and off but not with the consistency it did before. To show you the A$% I am, I have a warranty on the TV and if I would have used my head I would have set up a service appointment.
I must say that when I first got the TV the picture was incredible and I was pleased with it until this on and off thing started. I hope it can be put back to the way it was, I settle for the on and off as long as I get the quality back.
Chowhound
Comic Vine
GameFAQs
GameSpot
Giant Bomb
TechRepublic