The following are several factors that I would like to setup for quotation purposes in a plastic injection molding operation. Currently, several of the items produced are repeat orders, using the same materials. Essentially, I need to enter the qty ordered, unit weight, material type which would automtically select the per pound cost, file would then compute the final quantities and cost. Any suggestions for a quick and easy implementation? Thanks.
Qty Ordered
Due Date
Start Date
Target End Date
No of Cavities
Cycle Time [sec]
Unit Weight
Prdn Run Time
Shots Per Cycle
Resin Type
Total Resin Needed
Cost Per LB
Total Resin Cost
Unit Yield per LB
Resin Cost per Unit
Other
Labor
Press Time
Setup Charge
Direct/Indirect Cost
Unit Cost
Order Value

Chowhound
Comic Vine
GameFAQs
GameSpot
Giant Bomb
TechRepublic