Auto Repair forum


Electrical: Power to PDC and Startero power to Junction Box

by joeyk88 / December 13, 2015 7:53 AM PST

2000 jeep grand Cherokee.My friend bought this used grand Cherokee and it ran fine all the way home. The vehicle was not started again because the next morning water was on the floor boards. He is attempting to replace the heater core and needed to remove the carpet too . He started by removing the radio and other components on the dashboard. Most of the trim was removed along the dashboard as well. The transmissions selector housing was removed as well as the seats, driver and passenger and back seats. The Manual says to straighten the tires so the steering column can be removed once locked. He turned the key and nothing happened. No click or turning of the engine. The horn would not work and the headlights would not come on. We checked the battery and replaced it. The ignition still won't start and no horn or headlights. Check the voltage between the battery and the power distribution box and it was good. Fuses and relays were checked and replaced if needed. Voltage is getting to the cavity. Check voltage at junction box and no power. There is voltage to the generator. There is voltage to the starter. At connector C102 there is power at the terminals. At connector C106 there is no power. That's about as far as we got. Please... any help?

Discussion is locked
You are posting a reply to: Electrical: Power to PDC and Startero power to Junction Box
The posting of advertisements, profanity, or personal attacks is prohibited. Please refer to our CNET Forums policies for details. All submitted content is subject to our Terms of Use.
Track this discussion and email me when there are updates

If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem. Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended.

You are reporting the following post: Electrical: Power to PDC and Startero power to Junction Box
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
Popular Forums
Computer Newbies 10,686 discussions
Computer Help 54,365 discussions
Laptops 21,181 discussions
Networking & Wireless 16,313 discussions
Phones 17,137 discussions
Security 31,287 discussions
TVs & Home Theaters 22,101 discussions
Windows 7 8,164 discussions
Windows 10 2,657 discussions


Help, my PC with Windows 10 won't shut down properly

Since upgrading to Windows 10 my computer won't shut down properly. I use the menu button shutdown and the screen goes blank, but the system does not fully shut down. The only way to get it to shut down is to hold the physical power button down till it shuts down. Any suggestions?