General discussion

D-link G710 extender Setup

I have been trying to set up my D-link G710 to my Thompson 02 router. Have followed instructions and many articles on the web but without success.
I can login into the g710 I then open the wireless tab and set wireless network to my 02 router network I then open the network tab. This is where I think I get the problem I have to set network address (192.168.0.30) to match router network range which I enter 192.168.1.30. and leave gateway blank. (Router IP Address is 192.168.1.254) I then click the green tick and finish setup, disconnect lan cable and extender turn lan off on computer turn wireless on and try to connect to extender via wireless (I am using a TP Link wireless adapter) I assume I leave the adapter to find its own dynamic address as normal.
Thank you

Discussion is locked

Follow
Reply to: D-link G710 extender Setup
PLEASE NOTE: Do not post advertisements, offensive materials, profanity, or personal attacks. Please remember to be considerate of other members. If you are new to the CNET Forums, please read our CNET Forums FAQ. All submitted content is subject to our Terms of Use.
Reporting: D-link G710 extender Setup
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
Comments

CNET Forums

Forum Info