Settings:
Energy Saving: OFF
Picture Mode: isf Expert2
Backlight: 75
Contrast: 80
Brightness: 50
H Sharpness: 38
V Sharpness: 40
Color: 50
Tint: 0
Expert Control:
Dynamic Contrast: Off
Super Resolution: Off
Color Gamut: BT709
Edge Enhancer: High
Color Filter: Off
Gamma: 2.2
White Balance:
Color Temperature: Medium
Method: 20 Point IRE (IRE settings take about 20 minutes and you must do it)
Pattern: Outer
Luminance: 130
IRE Settings: (Make certain that you go to each color as listed below and also register each of the levels in each numeric category 100 through 5. So you go to Red and at the 100 value, you enter the 12,21,9. Then you go to 95 and enter the next result listed below. When you're done with Red then go to Green and start over)
IRE Value: Red, Green, Blue
100: 12,21,9
95: 50,50,40
90: 50,50,37
85: 42,22,32
80: 34,18,36
75: 40,20,42
70: 50,30,50
65: 50,34,46
60: 29,18,24
55: 24,11,26
50: 22,4,18
45: 24,12,22
40: 20,9,20
35: 18,10,18
30: 15,7,14
25: 4,0,4
20: 2,-1,2
15: 2,2,4
10: 10,8,2
5: -3,4,-16
Color Management System Settings:
Color: Saturation, Tint, Luminance
Yellow: -10,1,-2
Red: -6,5,17
Green: -10,8,4
Blue: 8,0,5
Cyan: 0,5,5
Magenta: 0,-1,4
Picture Option:
Noise Reduction: Off
MPEG Noise Reduction: Off
Black Level: Low
Real Cinema: On
LED Local Dimming: High
Just bought the LGLN5300 and looking for advice on the best picture settings to get the best look possible. Thanks!

Chowhound
Comic Vine
GameFAQs
GameSpot
Giant Bomb
TechRepublic