Autoplay: ON Autoplay: OFF
CNET News Video
Samsung explains why the Note 7 explodedThe phone was plagued by two separate battery manufacturing faults that affected the first and second shipments of the doomed Galaxy Note 7.
For the first part of our discussion, we will focus on the negative electrodes that are in the corner of the cell closest to the negative tab. For the second part of our discussion, attention will be focused on the interface between positive tab and the welds and the rest of the cell. Our investigation into root cause for the failure of cells provided by manufacturer a showed that damage to the outermost windings of the negative electrode closest to the negative tab of the cell was the most likely cause for the thermal failures. Through measurement and observation it was found that the negative electrodes were damaged because of the design of the cell pouch did not provide enough room. In the CT images, on the right side of the slide, there are arrows that point out the locations of the pouch. The top image is of a cell for manufacturer A. It can be seen that the curvature of the pouch causes it to come in contact with the negative electrodes causing the electrodes to be bent over. In contrast, the bottom image is of cell for manufacturer B. Showing that the pouch extends well beyond the ends of the negative electrodes, and provides enough room. Negative electrode damage like this is undesirable, because it could put strain on the separator, causing separator failure, and cell faulting Or it can cause negative active material delamination that can upset the local capacity balance resulting in plating and potential cell faulting. Cell faulting is a well-known root to the types of thermal failure that we've seen in these cells. Exponents findings related to the thermal failure of cells for Manufacturer B showed that manufacturing defects on the welds of the positive tab Were able to bridge the space between the positive tab and the neighboring negative electrode, resulting in cell faulting and, in some instances, thermal runaway. The weld defects were related to the height of the features left behind by the ultrasonic welder, used to attach the positive tab to the positive electrode current collector. Normal swelling and contraction of the electrodes during charge and discharge Forces the well defect features into the opposing negative electrode. Short circuit between the well defect feature on the positive tab and the copper of the negative electrode results in heating of the cell. At high states of charge, the cell heating results in thermal runaway.