CNET también está disponible en español.

Ir a español

Don't show this again

The HTC One takes form

HTC One from all angles

The One's 'Diamond Cut' edge

The One's camera placement

The One's swooping angles

The HTC One has a soft curve

The Aluminum unibody construction

An early look at the front and rear design of the One. Even early on, HTC wanted to put dual front speakers on the device with a "laser micro drill."
Caption by / Photo by HTC
The sketches include a look at the phone at various angles, as well as the rear case, which is cut completely out of aluminum.
Caption by / Photo by HTC
A look at the side profile of the device, with "diamond cut" edges that are reminiscent of the iPhone 5's own chamfered edges.
Caption by / Photo by HTC
HTC went through many iterations and ideas on where to put the camera before finally deciding to place it near the top in the center.
Caption by / Photo by HTC
HTC went through a lot of options for the top profile of the One before deciding on a rear case that swoops up as it gets closer to the center. One option included a perfectly flat back.
Caption by / Photo by HTC
HTC looked at how its customers held its phone, and opted for the "soft curve," which it believed would be easier to use.
Caption by / Photo by HTC
HTC boasts that the One features a "zero-gap construction" process that allows the phone to appear as if it's carved out of one sheet of metal. It actually takes more than 200 minutes to cut out and process the front and rear parts of the phone.
Caption by / Photo by HTC
Up Next
Best iPhone X cases