This TV died in November, 2010, and has been collecting dust in a corner ever since.

Read the full story of this TV repair project here.

Updated:
Caption by:
Removing the back panel was the first step.
Updated:
Caption by:
Inside, you can see the four main boards. The power board on the bottom, processor board on the top, and Y and Z sustain boards on either side.
Updated:
Caption by:
Removing the support beam was critical, as both the Y-SUS and power boards were connected to it.
Updated:
Caption by:
Getting the support beam out of the way was a time-consuming process.
Updated:
Caption by:
Lots of screws. I ended up putting most of them back.
Updated:
Caption by:
The suspect Y-SUS board.
Updated:
Caption by:
My replacement board, ordered from eBay.
Updated:
Caption by:
One of the many ribbon cables and connections I had to carefully remove.
Updated:
Caption by:
More connections on the Y-SUS board.
Updated:
Caption by:
Yet another tiny cable to watch out for.
Updated:
Caption by:
With the new board inserted, I tilted the set back upright to test it.
Updated:
Caption by:
These screws have to go back in there. Now, if I only remembered which one was which...
Updated:
Caption by:
An HDMI input via a laptop worked, surprising no one more than me.
Updated:
Caption by:
Hmmm...not really sure where these extra screws were from...
Updated:
Caption by:
The only tool I used during the entire process.
Updated:
Caption by:
Putting the cover panel back on was one of the final steps.
Updated:
Caption by:
Reattaching the back panel of the TV.
Updated:
Caption by:
A final successful video test, via HDMI.
Updated:
Caption by:
Does anyone want a blown Y-SUS board from a five-year-old plasma?
Updated:
Caption by:
Hot Galleries

Tech explained

Do you know what an OLED TV is?

CNET explains how OLED technology differs from regular TVs, and what you need to know to make the right shopping decision.

Hot Products