HDTV Picture Setting forum

Tip

LG 47LA6200 picture settings

by katzmaier CNET staff/forum admin / August 26, 2013 12:46 AM PDT

Review:
http://reviews.cnet.com/flat-panel-tvs/lg-47la6200/4505-6482_7-35576427.html

Related products:
LG 42LA6200
LG 50LA6200
LG 55LA6200
LG 60LA6200

Calibration report using these settings:
[see below]

TV software/firmware version tested: 04.00.20

Below you'll find the settings I found best for viewing the LG 47LA6200 in a dim room via the HDMI input. Your settings may vary depending on source, room conditions, and personal preference. Check out the Picture settings and calibration FAQ for more information.
http://news.cnet.com/8301-17938_105-9996461-1.html

Calibration notes: As usual the Cinema mode was the most accurate out of the box, although it was still quite minus-blue. A few tweaks to the two-point grayscale brought it to near-perfection, however, to the extent that we didn't bother with the multipoint control. Color was also similarly superb, so much so that we didn't perform any tweaks of the color management system.

The Dynamic Contrast mode doesn't do very much; the difference bwteeen on and off was only visible by our meter. No mode performs any local dimming of the edge-light.

Picture menu:
Energy Saving: Off
Picture Mode: Expert [1 or 2]
Backlight: 50
Contrast: 80
Brightness: 53
H Sharpness: 0
V Sharpness: 0
Color: 50
Tint: 0
Aspect Ratio: Just Scan

--Expert control menu--
Dynamic contrast: Off
Super Resolution: Off
Color Gamut: Standard
Edge Enhancer: Off
xvYCC: Auto [grayed out]
Color Filter: Off
Expert Pattern: Off [grayed out]
Gamma: 2.2

--White Balance submenu--
Color Temperature: Warm
Method: 2-points [do not adjust 20-point]
Pattern: Outer
Points: [High]
Red: 6
Green: 0
Blue: 23
Points: [Low]
Red: 0
Green: 0
Blue: -3

--Color management system submenu--
[no changes; all settings "0"]

Red: [Saturation 6. Tint 3, Luminance 3]
Green: [Saturation -2. Tint 6, Luminance 6]
Blue: [Saturation 0, Tint 0, Luminance 0]
Cyan: [Saturation 0. Tint 4, Luminance 4]
Magenta: [Saturation 20. Tint 0, Luminance 0]
Yellow: [Satu
ration 0. Tint 0, Luminance 0]

--Picture Option menu--
Noise reduction: Off
MPEG Noise Reduction: Off
Black Level: Low
Real Cinema: On
Motion Eye Care: Off [grayed out]
TruMotion: Off

Note: This post was edited by its original author Fixed errant TruMotion setting; it should be "Off." See review for details. on 08/27/2013 at 5:30 AM PT

Post a reply
Discussion is locked
You are posting a reply to: LG 47LA6200 picture settings
The posting of advertisements, profanity, or personal attacks is prohibited. Please refer to our CNET Forums policies for details. All submitted content is subject to our Terms of Use.
Track this discussion and email me when there are updates

If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem. Also please exercise your best judgment when posting in the forums--revealing personal information such as your e-mail address, telephone number, and address is not recommended.

You are reporting the following post: LG 47LA6200 picture settings
This post has been flagged and will be reviewed by our staff. Thank you for helping us maintain CNET's great community.
Sorry, there was a problem flagging this post. Please try again now or at a later time.
If you believe this post is offensive or violates the CNET Forums' Usage policies, you can report it below (this will not automatically remove the post). Once reported, our moderators will be notified and the post will be reviewed.
Collapse -
CNET calibration results
by katzmaier CNET staff/forum admin / August 26, 2013 3:15 AM PDT
Collapse -
Real cinema greyed out
by VanillaMillz / September 9, 2013 3:19 PM PDT

Real Cinema is turned off and greyed out on my tv. How do I turn it on.

Collapse -
LG 47LA6200 p[cture settings
by ozzy44 / November 29, 2013 2:21 PM PST

On LG 42LA6200 do NOT have sub-menu for color management. Have 2 "warm" white balance settings. Which one was used in your calibration? Also, how accurate will calibration be using the built-in "set-up wizard"? Thanks.

Popular Forums
icon
Computer Help 47,885 discussions
icon
Computer Newbies 10,322 discussions
icon
iPhones, iPods, & iPads 3,188 discussions
icon
Security 30,333 discussions
icon
TVs & Home Theaters 20,177 discussions
icon
HDTV Picture Setting 1,932 discussions
icon
Phones 15,713 discussions
icon
Windows 7 6,210 discussions
icon
Networking & Wireless 14,510 discussions

Tech for the school year

Smart tech for smart students

Forget the pencils and notebooks. Gear up your students with these portable and powerful note-taking machines.